Make-n-Take - PVC Pencil Holder

PDF Format
Materials:
- Two - 1/2 in. PVC Pressure Tee Connectors
- One - 1/2 in. PVC Nipple, or cut 4 in. from length
- One - 1/4 in. x 1 in. thumb screw
- Add protective covering on thumb screw (ex. pencil grip purchased from Wal-mart)
(PVC and other materials are available at Home Depot, Lowe's or similar hardware store.

Directions:
1. Drill a 1/4 in. hole into one of the PVC Tees. Locate the hole at the center of the tee (see diagram).
2. Assemble the pencil holder by attaching a PVC Tee to each end of the PVC Nipple. The parts may be threaded and will screw together.
3. Thread the thumbscrew into the drilled hole.
4. Place pencil, marker or paintbrush into the Tee and tighten with the thumbscrew until secure. Add protective covering over thumbscrew.

pvc made pencil holder

The Oklahoma Assistive Technology Project, Oklahoma ABLE Tech, is funded by the National Institute on Disability and Rehabilitation Research of the U.S. Department of Education. To contact OK ABLE Tech call 1-800-257-1705 or INFO-line 1-888-885-5588